2=Point Program; Loop Select; Detector Programming - Honeywell Fire-Lite Alarms ES-1000X Manual

Programming
3.5.2 Point Program
PROGRAMMING
1=AUTOPROGRAM

2=POINT PROGRAM

3=ZONE SETUP
Programming Screen #1

Loop Select

Press the corresponding number to program the desired loop. The ES-1000 comes standard with one loop. Additional SLC-3LS modules are
required to expand the system to three SLC loops.
POINT PROGRAM
1=DETECTOR
2=MODULE
Programming Screen #1

Add Detector
Pressing 1 while viewing the Detector Screen will display the following screen which allows the programmer to add a new detector address
to programming:
A flashing cursor will appear in the position of the first asterisk to the left. The programmer keys in the three digit detector address, such as
005. The screen will then ask whether the detector being added is wireless.
Select 1 for wired detector or 2 for wireless detector. When the choice is selected, the following screen will be displayed:
Press the down arrow key to view additional choices. Press the number corresponding to the desired selection to program that type to the
newly added detector. If the selected detector is a multi-criteria Fire/CO detector, select 1 for Fire CO. When the type has been selected, the
following screen will be displayed:
NOTE: The system must be monitored by a Supervising Station when using carbon monoxide detection per The Requirements for the
Installation of Carbon Monoxide (CO) Detection and Warning Equipment, NFPA 720.
The programmer can continue adding detectors by pressing the ESC key which will return the display to the Add Detector Screen.
50
The Point Program option allows the programmer to add a new addressable device to an SLC loop, delete an
existing device from the loop or change the programming for an existing device. Pressing 2, while viewing Pro-
gramming Screen #1, will select the Point Program option and display the following screen:
POINT PROGRAM, LOOP:
1=LOOP 1
2=LOOP 2
3=LOOP 3

Detector Programming

Pressing 1, while viewing the Point Program Screen, will allow the programmer to add, delete or change the
programming of an addressable detector. The following screen will be displayed by the control panel:
1=ADD
2=DELETE
3=EDIT
ENTER DETECTOR#
1=DETECTOR
2=DETECTOR: WIRELESS
DETECTOR TYPE
1=SMOKE(PHOTO)
2=USER-DEFINED-1
3=SMOKE(ION)
DETECTOR#
IS ADDED
Point Program Screen
DETECTOR
Detector Screen
ADD DETECTOR
Add Detector Screen
ADD DETECTOR
Add Detector Screen
DETECTOR TYPE
1=USER-DEFINED-14
through
2=DET_HIGH_HEAT
3=USED-DEFINED-15
ADD DETECTOR
005
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Master Programming Level