Point Program; Detector Programming; Add Detector - Honeywell Fire-Lite Alarms MS-9050UD Manual

3.6.2 Point Program

The Point Program option allows the programmer to add a new addressable device to an SLC loop,
delete an existing device from a loop or change the programming for an existing device. Pressing
2, while viewing Programming Screen #1, will select the Point Program option and display the
following screen:
PROGRAMMING
1=AUTOPROGRAM
2=POINT PROGRAM
3=ZONE SETUP
Programming Screen #1
MS-9050UD PN 52413:C 01/23/08
1=DETECTOR
2=MODULE

3.6.2.1 Detector Programming

Pressing 1, while viewing the Point Program Screen, will allow the programmer to add, delete
or change the programming of an addressable detector. The following screen will be displayed
by the control panel:
1=ADD
2=DELETE
3=EDIT

3.6.2.1.1 Add Detector

Pressing 1 while viewing the Detector Screen will display the following screen which allows
the programmer to add a new detector address to programming:
ENTER DETECTOR#
***
A flashing cursor will appear in the position of the first asterisk to the left. The programmer
keys in the three digit detector address, such as 005.
When the last digit is keyed-in, the following screen will be displayed:
1=SMOKE(PHOTO)
2=USER-DEFINED-1
3=SMOKE(ION)
Press the down arrow key to view additional choices. Press the number corresponding to the
desired selection to program that type to the newly added detector.
POINT PROGRAM
SELECT TYPE
Point Program Screen
DETECTOR
Detector Screen
ADD DETECTOR
Add Detector Screen
DETECTOR TYPE
Programming
57