Honeywell Fire-Lite Alarms ES-1000X Manual page 33

Optional Module Installation

Installation
Ensure that all power (AC and DC) has been removed from the FACP before installing the annunciator.

Opening/Closing Annunciator
The following procedure details the steps used to open the annunciator in order to access the terminal block and DIP switches (refer to figure
below):
1. Turn the key switch to the ON (Unlocked) position by turning the key counter-clockwise.
2. Push in the snap latch located on the right side of the unit while pulling the cover open.
3. To close the cover, make certain the key switch is in the ON (Unlocked) position. Swing the cover closed, snapping it shut.
4. Turn the key switch to the OFF (Locked) position by turning clockwise and remove the key.

Mounting
The ANN-80 can be surface or semi-flush mounted to a single, double or 4" square electrical box. Select and remove the appropriate knock-
out(s), pull the necessary wires through the knockouts and mount the annunciator in or on the wall depending on the type of installation
desired.
The ANN-SB80KIT(-R/-B/-W) is an available mounting kit for the ANN-80 annunciator. The kit comes with a surface backbox and surface
wedge for angled viewing. The two pieces can be used separately or can be stacked together.
The ANN-80 cover must be attached to the annunciator backplate before mounting the annunciator to the electrical box/wall. The cover can-
not be reattached or removed after the annunciator has been mounted.
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Annunciator cover
with LCD display
Key switch shown in
OFF/Locked position
Annunciator mounted on
surface wedge from the
ANN-SB80KIT
Annunciator mounted on
surface backbox from the
ANN-SB80KIT
Annunciator backplate
Press in latch
and
Pull annunciator
cover open
Annunciator mounted on stacked
surface wedge and backbox from
the ANN-SB80KIT
Installation
33