8: History; 9: Annunciators; 10: Communicator - Honeywell Fire-Lite Alarms ES-1000X Manual

Read Status
4.23.8 History
Pressing 3 while viewing Read Status Screen #3 will display the following screen:
The operator can view all events which have been stored in the history file, only alarms or other events, such as troubles or supervisories, by
pressing the corresponding number key.
4.23.9 Annunciators
READ STATUS
1=ANNUNCIATORS
2=COMMUNICATOR
3=NOT USED
Read Status Screen #4
Pressing 1 or 2 for ANN-BUS while viewing the Annunciator Screen allows the operator to view the settings and devices for each ANN-
BUS. Press 1 for the Primary ANN-BUS and 2 for the Secondary ANN-BUS.
The ANN-BUS Screen #1 indicates if the ANN-BUS has been enabled Yes or disabled No.
Pressing 2 for Modules Installed while viewing ANN-BUS Screen #1 will display screens for ANN-BUS Addresses 1 -8 and the devices
installed at each address. A subscreen will display the options that have been programmed for each device.
ANN-BUS SELECT
1=PRIMARY
2=SECONDARY
3=ANN-BUS OPTIONS
Annunciator Screen
Pressing 1 for ANN-S/PG Options while viewing ANN-BUS Screen #2 will display the options selected for the installed ANN-S/PG annun-
ciators.
Pressing 2 for ANN-LED Options while viewing ANN-BUS Screen #2 will display the options selected for the installed ANN-LED annunci-
ators.
Pressing 3 for ANN-80/100 Options while viewing ANN-BUS Screen #2 will display the options selected for the installed ANN-80/ANN-
100 annunciators.
4.23.10 Communicator
READ STATUS
1=ANNUNCIATORS
2=COMMUNICATOR
3=NOT USED
Read Status Screen #4
COMMUNICATOR
INSTALLED YES
2=POTS SETTINGS
3=IP SETTINGS
Communicator Screen #1
The Communicator Screen #1 indicates if an IPOTS-COM has been installed Yes or No.
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
Pressing 1 while viewing Read Status Screen #4 will display the following screens:
1=PRIMARY
2=SECONDARY
3=ANN-BUS OPTIONS
ANN XXXXXXXX
ENABLED
2=MODULES INSTALLED
CLASS A
Pressing 3 for ANN-BUS Options while viewing the Annunciator Screen allows the operator to view the settings
for any ANN-S/PG, ANN-LED, and ANN-80/ANN-100 installed in the system.
1=ANN-S/PG OPTIONS
2=ANN-LED OPTIONS
3=ANN-80/100 OPTIONS
Pressing 2 while viewing Read Status Screen #4 will display the following screens:
COMMUNICATOR
1=PRI COMM PATH
2=SEC COMM PATH
TBL REPORT LIMIT
Communicator Screen #2
HISTORY
ANN-BUS SELECT
Annunciator Screen
NO
NO
ANN-BUS Screen #1
ANN-BUS
ANN-BUS Screen #2
COMMUNICATOR
1=EVENT CODES
TEST TIME INT
0 24HR TEST TIME
Communicator Screen #3
Operating Instructions
COMMUNICATOR
REPORT STYLE
24
0100
Communicator Screen #4
POINT
113