Ann-I/O Led Driver Module - Honeywell Fire-Lite Alarms ES-1000X Manual

Optional Module Installation
Setting Printer Options
Refer to the documentation supplied with the PRN-6F printer for instructions on using the printer menu controls. Set the printer options
(under the menu area) as shown in the following table:

ANN-I/O LED Driver Module

The ANN-I/O must be mounted within 20' (6.1m) of the FACP in the same room and wired in conduit.

ANN-I/O Board Layout
Figure 2.20 illustrates the ANN-I/O board showing locations of screw terminals for connection to the FACP, pin connectors for connecting
LEDs and the DIP switch for selecting the ANN-BUS ID number.
1
LED Out
LED Power
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Option
Font HS Draft
LPI 6 LPI
ESC Character ESC
Bidirectional Copy ON
CG-TAB Graphic
Country E-US ASCII
Auto CR OFF
Color Option Not Installed
Formien
Lines 6LPI=60
Standard Exec 10.5
10 11
20 21
LED Out
LED Out
LED Power
LED Power
not used not used
ANN-BUS Connector
Figure 2.20 ANN-I/O Board Layout
Setting Option
CPI
Skip
Emulate
I/O
Buffer
Serial
Baud
Format
Protocol
Character Set
SI.Zero
Auto LF
PAPER
BIN 1
BIN 2
SINGLE
PUSH TRA
PULL TRA
PAP ROLL
Table 2.2 PRN-6 Setup Options
31
30 40
LED Out
LED Power
not used
not used
Setting
10CPI
0.5
Epson FX-850
40K
9600 or 2400
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
On
12/72"
12/72"
12/72"
12/72"
12/72"
12/72"
ANN-BUS (ID#)
Address Dip switch
Installation
37