Ip Settings - Honeywell Fire-Lite Alarms ES-1000X Manual

Programming

Gains
POTS SETTINGS
1=LINE 1
2=LINE 2
3=GAINS
POTS Settings Screen
The Gains value can be adjusted for when the telephones lines are in use for Dialing and Reporting. Press 1 or 2 to change these values,
respectively. The following screen will display for both options.
Press 1 for Low, 2 for Normal, and 3 for High. After the Gains value has been selected, the display will return to the Gains Screen.

IP Settings

COMMUNICATOR
1=INSTALLED
2=POTS SETTINGS
3=IP SETTINGS
Communicator Screen #1

DHCP Enabled
If the internet router used by the IPOTS-COM is configured for DHCP (Dynamic Host Configuration Protocol) where addresses are auto-
matically assigned, press 1 while viewing the IP Settings Screen to change the display to Enabled Yes. Each press of the 1 key will cause the
display to toggle between Enabled Yes and Enabled No. If the DHCP is enabled, the Static Settings option will disappear since there is no
need to enter addresses manually.

Static Settings
IP SETTINGS
1=DHCP ENABLED
2=STATIC SETTINGS
3=ENTER PIN
IP Settings Screen
STATIC SETTINGS
DEVICE IP ADDRESS
XXX.XXX.XXX.XXX
Device IP Address Screen
The A flashing cursor will appear on the first X to the left. Enter the twelve digit address. When the address has been entered, press the Enter
key to store the address number. The display will return to the IP Settings Screen.

PIN
IP SETTINGS
1=DHCP ENABLED
2=STATIC SETTINGS
3=ENTER PIN
IP Settings Screen
Enter the 4 digit PIN provided by AlarmNet and press Enter. The display will indicate that it is sending the PIN to AlarmNet for verification.
80
The Gains value is the telephone's transmitting "volume control". To adjust the settings, press 3 while viewing
the POTS Settings screen. The following screen will be displayed:
The IP settings configure the system when the central station will be contacted over the internet. The following
screens allow the user to enter the device addresses needed for communication. Pressing 3 while viewing the
YES
Communicator Screen #1 will display the following.
IP SETTINGS
1=DHCP ENABLED
2=STATIC SETTINGS
3=ENTER PIN
IP Settings Screen #1
The Static Settings are used to set the addresses manually if the DHCP is not enabled. Press 2 on the IP Settings
Screen. The following screens will display:
NO
STATIC SETTINGS
SUBNET MASK
XXX.XXX.XXX.XXX
Subnet Mask Screen
In the event that the communicator needs to be replaced, the device will need to be re-registered with AlarmNet.
NO
AlarmNet will issue a PIN to be entered into the panel for verification. Pressing 3 on the IP Settings screen will
display the following.
GAINS
1=DIALING NORM
2=REPORTING NORM
Gains Screen
GAINS
1=LOW
2=NORMAL
3=HIGH
Gains Screen
NO 1=ETHERNET FAULT 01
MAC CRC
STATIC SETTINGS
GATEWAY IP ADDRESS
XXX.XXX.XXX.XXX
Gateway IP Address Screen
IP SETTINGS
ENTER 4 DIGIT
PIN NUMBER
PIN Number Screen
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Master Programming Level
IP SETTINGS
C3F0
IP Settings Screen #2
STATIC SETTINGS
PREFERRED DNS
XXX.XXX.XXX.XXX
Preferred DNS Screen