Honeywell Fire-Lite Alarms ES-1000X Manual page 34

Installation

Wiring ANN-80 to FACP
The following steps can be used as a guide to wire the annunciator. Make certain all power has been removed from the FACP prior to annun-
ciator installation.
1. Route wires from hole in backplate, through wiring channel and then to ANN-80 terminal block TB1
2. Remove appropriate amount of wire insulation
3. Connect the wiring from the FACP ANN-BUS to annunciator TB1 terminals 3 (A) & 4 (B). Make certain to connect A to A and B to B
4. If appropriate, connect the wiring going to the next device on the ANN-BUS to TB1 terminals 3 & 4. Make certain to connect A to A
and B to B
5. Connect the wiring from the 24 VDC power source to annunciator TB1 terminals 1 (-) & 2 (+). Make certain to observe proper polarity
6. If appropriate, connect the power wiring going to the next device to terminals
1 (-) & 2 (+). Make certain to observe proper polarity
7. After all connections are made, remove extra wire from inside of annunciator by dressing it neatly through wire channel, with any
excess wire pushed back through hole into electrical box
The following table shows the ANN-80 connections to the ES-1000X. Note that older models of the ANN-80 will only have one terminal
block and TB2 is not available.

Programming
Following installation and wiring of the ANN-80 LCD annunciator to the FACP, the annunciator must be added to the system via FACP pro-
gramming. Refer to the programming section titled "ANN-BUS Setup" on page 87 in this manual for detailed programming information.
Select the LCD option for programming.
34
wiring channel
wires
TB1
TB2
ANN-BUS and DC power wiring are supervised and power-limited
ANN-80
Figure 2.18 ANN-80 Wiring to FACP
ES-1000X
Terminal GND (-) on TB11
Terminal PWR (+) on TB11
Terminal Data (A) on TB9
Terminal Data (B) on TB9
ES-1000X
Earth Ground
Primary
24 VDC
non-resettable
ANN-BUS
ES-1000X
ANN-80 (TB1)
Terminal 1 (-)
Terminal 2 (+)
Terminal 3 (A)
Terminal 4 (B)
ANN-80 (TB2)
Terminal 1
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Optional Module Installation