1: Disable Point; 2=History - Honeywell Fire-Lite Alarms ES-1000X Manual

Programming
3.6.1 Disable Point
PROGRAMMING
1=POINT PROGRAM

2=HISTORY

3=PROGRAM CHECK
Maintenance Screen #1
Select the corresponding number for the loop with the desired point.
Select the device type by pressing 1 for an addressable detector or 2 for an addressable module. The operator will be prompted to enter the
three digit device address as shown in the following example for a detector:
A flashing cursor will appear in the bottom left corner of the display, prompting for the three digit device address. When the third digit is
enter, 001 for example, a screen will appear which will allow enabling or disabling of the selected point, as illustrated in the following exam-
ple:
Pressing 1 repeatedly will cause the display to toggle between Enabled Yes and Enabled No.
3.6.2 History
PROGRAMMING
1=POINT PROGRAM
2=HISTORY
3=PROGRAM CHECK
Maintenance Screen #1
The History feature allows the operator to view control panel events which have been stored in a history file in memory and erase the con-
tents of the history file
Pressing 1 while viewing the History screen will cause the following screen to be displayed:
To view all the events which have occurred in the control panel since the history file was last erased, press 1 while viewing the Events
screen. To view only alarms which have occurred, press 2 while viewing the Events screen. To view events other than alarms, press 3. The
most recent event will be displayed on the screen. To view all of the selected events, press the up or down arrow keys to scroll through the
list of events. If no events have occurred, the display will read NO EVENTS IN HISTORY.
Pressing 2 while viewing the History Screen will cause the following screen to be displayed:
98
Pressing 1 for Point Program, while viewing Maintenance Screen #1 will cause the following screens to be dis-
played:
POINT PROGRAM, LOOP:
1=LOOP 1
2=LOOP 2
3=LOOP 3
Device Select Screen
POINT PROGRAM
1=DETECTOR
2=MODULE
Device Select Screen
EDIT DETECTOR
ENTER POINT ADDRESS
Address Select Screen
EDIT DETECTOR 1D001
1=ENABLED
Enable/Disable Select Screen
Pressing 2 while viewing Maintenance Screen #1 will cause the following screen to be displayed:
1=VIEW EVENTS
2=ERASE HISTORY
1=VIEW ALL
2=VIEW ALARMS
3=VIEW OTHER EVENTS
ERASE HISTORY
1=YES
Erase History Screen
YES
HISTORY
History Screen
HISTORY
Events Screen
PROCEED?
2=NO
ES-1000X Series Manual — P/N LS10133-000FL-E:A 6/21/2023
Maintenance Programming Level