Honda CBR650RA Shop Manual page 97

dummyhead dummyhead
REAR BRAKE
Support the motorcycle upright position on a level
surface and check the rear brake fluid level.
If the level is near the "LOWER" level line [1], fill the
brake fluid as follows.
Remove the following:
Take care not to
spill the fluid out of
– Reservoir mounting bolt [1]
the reservoir.
– Two screws [2]
– Reservoir cap [3]
– Set plate [4]
– Diaphragm [5]
Temporarily install the reservoir [6] onto the reservoir
stay with the mounting bolt secure it so the reservoir is
level.
Fill the reservoir with DOT 4 brake fluid from a sealed
container to the upper level line [7].
Carefully remove the reservoir from the stay by
removing the mounting bolt.
Install the diaphragm, set plate, reservoir cap and
tighten the screws to the specified torque.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
MAINTENANCE
[1]
[2]
[1]
[3]
[4]
[5]
[6]
[7]
3-19