Honda CBR650RA Shop Manual page 369

dummyhead dummyhead
Pull the slide pipe assembly [1] out until you feel
resistance from the slider bushing. Then move it in and
out, tapping the bushing lightly until the outer tube [2]
separates from the slide pipe assembly.
The guide bushing will be forced out by the slider
bushing.
Slightly spread the end of the piston B ring [1] and
remove it.
Carefully remove the slider bushing [2] by prying the
Do not damage the
slot with a screwdriver until the slider bushing can be
slider bushing,
pulled off by hand.
especially the
sliding surface. To
Remove the following:
prevent loss of
– Guide bushing [3]
tension, do not open
– Back-up ring [4]
the slider bushing
– Oil seal [5]
more than
– Stopper ring [6]
necessary.
– Dust seal [7]
Loosen the lock nut [1] while holding the fork cap [2],
then remove the fork cap.
Remove the O-ring [3] from the fork cap groove.
Remove the stopper seat [4], rod guide case [5],
rebound spring [6] and piston ring [7].
Remove the O-ring [8] from the rod guide case.
FRONT WHEEL/SUSPENSION/STEERING
[1]
[6]
[7]
[5]
[8]
[6]
[7]
[2]
[5]
[4]
[3]
[2]
[1]
[2]
[4]
[3]
[1]
16-27