Key Registration Procedures; Ko, Iiko Models) - Honda CBR650RA Shop Manual

dummyhead dummyhead
IMMOBILIZER SYSTEM (HISS)

KEY REGISTRATION PROCEDURES

(ED, IIED, IIIED, IVED, FO, IIFO, KO, IIKO models)
When the key has been lost, or additional spare key is required:
1. Obtain a new transponder key.
2. Grind the key in accordance with the shape of the original key.
3. Connect the SCS short connector to the DLC (page 22-11).
4. Open the throttle grip 5 ° to 60 ° and hold.
5. Turn the engine stop switch " " and the ignition switch ON with the original key. The HISS indicator comes on and it remains on.
• The code of the original key recognized by the ECM.
• If there is any problem in the immobilizer system (HISS), the system will enter the diagnostic mode and the indicator will remain
on for approx. ten seconds, then it will indicate the diagnostic code (page 22-12).
6. Wait two seconds or more, then completely close the throttle grip.
7. Wait two seconds or more, then open the throttle grip fully and hold.
8. Wait two seconds or more, then the indicator remains on for approx. two seconds, then it blinks four times repeatedly.
ON
OFF
• The immobilizer system (HISS) enters the registration mode. Registrations of all key except the original key inserted in the
ignition switch are cancelled (Registration of the lost key or spare key is cancelled).
The spare key must be registered again.
• Complete the procedure 5 through 7 within 25 seconds. If 25 seconds or more have passed, restart from the step 4.
9. Turn the ignition switch OFF and remove the key. Completely close the throttle grip.
10.Open the throttle grip 5 ° to 60 ° and hold.
11.Turn the ignition switch ON with a new key or the spare key (Never use the key registered in previous steps). The indicator
comes on for two seconds then it blinks four times repeatedly.
ON
OFF
• The new key or spare key is registered in the ECM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 22-12).
• Keep the other transponder key away from the immobilizer receiver more than 50 mm (2.0 in).
12.Turn the ignition switch OFF and remove the key. Completely close the throttle grip.
13.Repeat the steps 9 through 11 when you continuously register the other new key.
The ECM can store up to four key codes (The four keys can be registered).
14.Disconnect the SCS short connector.
15.Turn the ignition switch ON with the registered key.
• The immobilizer system (HISS) returns to the normal mode.
16.Check that the engine can be started using all registered keys.
22-4
2 sec.
2 sec.