Honda CBR650RA Shop Manual page 83

dummyhead dummyhead
Throttle grip freeplay can be adjusted at either end of
the throttle cable.
Major adjustment is made with the lower adjuster on the
throttle body.
Remove the air cleaner housing (page 7-12).
Loosen the lock nut [1] and turn the adjuster [2] as
required.
Tighten the lock nut to the specified torque while
holding the adjuster.
TORQUE: 5.5 N·m (0.6 kgf·m, 4.1 lbf·ft)
Minor adjustment is made with the upper adjuster of the
throttle grip side.
Slide the boot [1] to remove it from the adjuster [2].
Loosen the lock nut [3] and turn the adjuster as
required.
Tighten the lock nut to the specified torque while
holding the adjuster.
TORQUE: 3.8 N·m (0.4 kgf·m, 2.8 lbf·ft)
Install the boot over the adjuster properly.
After adjustment, recheck the throttle operation.
Install the air cleaner housing (page 7-12).
AIR CLEANER
• The viscous paper element type air cleaner cannot
be cleaned because the element contains a dust
adhesive.
• If the motorcycle is used in unusually wet or dusty
areas, more frequent inspections are required.
Lift the fuel tank and support it (page 3-4).
Disconnect the IAT sensor 2P (Black) connector [1].
Disconnect the following from the air cleaner lid [2]:
– Crankcase breather hose [3]
– Air supply hose [4]
– Ignition switch 2P (Brown) connector [5]
– Immobilizer receiver 4P (Black) connector [6]
– Wire clip [7]
Remove the tapping screws [1] and air cleaner lid [2].
[2]
[1]
[3]
[7]
[5]
[2]
[1]
[1]
MAINTENANCE
[1]
[2]
[6]
[4]
[3]
[2]
3-5