dummyhead
dummyhead
EVAP CANISTER
(Except MA, IIMA, IN, U, IIU models)
REMOVAL/INSTALLATION
Release the EVAP canister drain hose [1] from under
CBR650RA:
cowl [2] and harness clip [3].
Release the EVAP canister drain hose from hose clamp
CB650RA:
and harness clip.
Disconnect the following from the EVAP canister [1]:
– Fuel tank-to-EVAP canister hose [2]
– Canister-to-EVAP purge control solenoid valve hose
[3]
Remove the two mounting bolts [4] and EVAP canister.
Remove the heat guard [1] by releasing the tabs [2]
from the grooves of the rubber mount [3].
Disconnect the following:
– EVAP canister drain hose [4]
– EVAP canister breather hose [5]
Remove the bolt [6] and collar [7].
Remove the EVAP canister stay [8] by releasing the tab
[9] from the groove of the rubber mount.
Installation is in the reverse order of removal.
CBR650RA shown:
[3]
[2]
[8]
[6]
[7]
FUEL SYSTEM
[3]
[1]
[2]
[1]
[4]
[4]
[9]
[2]
[1]
[2]
[5]
90°
[3]
7-23