dummyhead
dummyhead
DIAGNOSTIC CODE INDICATION
ED, IIED, IIIED, IVED, FO, IIFO, KO, IIKO models
Turn the ignition switch OFF.
Remove the main seat (page 2-11).
Remove the dummy connector [1] from the DLC [2] and short DLC terminals
using the special tool.
TOOL:
SCS short connector [3]
Open the throttle grip 5 ° to 60 ° and hold.
Turn the engine stop switch " " and the ignition switch ON with the properly
registered key.
The HISS indicator [1] will come on for approx. ten seconds then it will start
blinking to indicate the diagnostic code if the system is abnormal.
The blinking frequency is repeated.
The HISS indicator remains on when the system is normal (The system is in
the normal mode and the diagnostic code does not appear).
MA, IIMA, IN, TH, IITH, U, IIU, BR, IIBR models
Turn the ignition switch OFF.
Disconnect the CKP sensor 2P (Black) connector [1].
Connect the adaptors to the wire harness side connector.
Connect the Red clip [2] of the adaptor to the 12 V battery positive (+)
terminal and Black clip [3] to the negative (–) terminal.
TOOLS:
[4] Inspection adaptor
[5] Test harness adaptor
Turn the engine stop switch " " and the ignition switch ON with the properly
registered key.
The HISS indicator will come on for approx. ten seconds then it will start
blinking to indicate the diagnostic code if the system is abnormal.
The blinking frequency is repeated.
The HISS indicator remains on when the system is normal (The system is in
the normal mode and the diagnostic code does not appear).
070MZ-0010300
07XMZ-MBW0101
070MZ-MGE0100
IMMOBILIZER SYSTEM (HISS)
[1]
[2]
[5]
[4]
[3]
[2]
[3]
[1]
22-11