Honda CBR650RA Shop Manual page 361

dummyhead dummyhead
Drive in a new left side bearing squarely with the
marked side facing up until it is fully seated.
Install the distance collar.
Drive in a new right side bearing squarely with the
marked side facing up until it is fully seated.
TOOLS:
[1] Driver
[2] Attachment, 42 x 47 mm
[3] Pilot, 20 mm
TIRE VALVE REMOVAL/
INSTALLATION
Remove the tire.
Remove the nut [1], tire valve [2] and O-ring [3].
If a puncture repair product was used, thoroughly clean
the inside of the wheel rim.
Clean the valve installation area of the rim with a
degreasing agent.
Install a new O-ring onto the tire valve.
Do not apply grease
to the O-ring.
Gradually screw in the tire valve and position it with the
valve neck facing the right of the motorcycle and
parallel with the axle.
Make sure the valve seating surface is fully seated on
the wheel and tighten the valve nut while holding the
tire valve.
TORQUE: 6.5 N·m (0.7 kgf·m, 4.8 lbf·ft)
After the tire valve installation, confirm the following
items.
– The tire valve neck is facing to the right side and
parallel to the axle direction.
Install the tire.
INSTALLATION
Install the right and left side collars [1].
FRONT WHEEL/SUSPENSION/STEERING
07749-0010000
07746-0010300
07746-0040500
RIGHT SIDE:
[2]
[2]
[1]
Rotating Direction
90°
LEFT SIDE:
[1]
[1]
[3]
[3]
16-19