Honda CBR650RA Shop Manual page 396

dummyhead dummyhead
REAR WHEEL/SUSPENSION
SWINGARM
REMOVAL/INSTALLATION
Remove the following:
– Drive chain cover/mud guard (page 2-16)
– Rear wheel (page 17-4)
– EVAP canister (Except MA, IIMA, IN, U, IIU models)
(page 7-23)
Remove the bolt [1], brake pipe stay [2] and brake pipe
[3].
Remove the shock absorber lower mounting nut [1] and
bolt [2].
Slide the shock absorber up and remove the collars [3].
Remove the following:
– Pivot caps [1]
– Pivot nut [2]
– Washer [3]
– Pivot bolt [4]
Move the brake hose, speed sensor wire and drive
Support the caliper
chain out of the way and remove the swingarm from the
so it does not hang
frame.
from the brake
hose. Do not twist
Installation is in the reverse order of removal.
the brake hose
• The pivot bolt is installed from the left side.
• Apply engine oil to the threads and seating surface
of the pivot nut.
• Install the pivot cap by aligning the tabs with the cut-
out of the frame.
TORQUE:
Swingarm pivot nut:
103 N·m (10.5 kgf·m, 76 lbf·ft)
Shock absorber mounting nut:
44 N·m (4.5 kgf·m, 32 lbf·ft)
17-10
[2]
[3]
[1]
[1] [4]
Align
[1]
[2]
[3]
[2]/[3]