Honda CBR650RA Shop Manual page 471

dummyhead dummyhead
CB650RA:
Remove the left shroud (page 2-10).
Disconnect the Torque control switch 3P (Black)
connector [1].
Check for continuity between the switch side 3P (Black)
connector terminals in each switch position according to
the continuity chart.
– ED, IIIED, FO, KO models (page 23-4)
– MA, IN, TH, U, BR models (page 23-5)
TURN SIGNAL RELAY
REMOVAL/INSTALLATION
Remove the ABS modulator cover (page 4-76).
Turn the ignition switch OFF.
Remove the turn signal relay [1] from the stay.
Disconnect the 8P (Gray) connector.
Installation is in the reverse order of removal.
SYSTEM INSPECTION
• If any LED in the turn signal light does not turn on, replace the turn signal light (page 21-4).
• The turn signal lights are controlled by the LED turn signal relay.
• CB650RA (Except IN model): The front turn signal lights have position light function.
• If there is an open circuit in the one (front or rear) turn signal light, the other turn signal light blinks faster than
usual in order to notify the rider of the problem.
• The hazard flasher system can be operated with the ignition switch turned ON.
• Check the following before troubleshooting:
– Battery condition
– 7.5A METER/HORN/TAIL/TURN fuse
– Turn signal switch and hazard switches
LIGHTS/METERS/SWITCHES
[1]
[1]
21-21