Honda CBR650RA Shop Manual page 441

dummyhead dummyhead
Remove the bolt [1] and brake pipe stay [2].
Release the rear wheel speed sensor wire [3] from the
stay [4] and clamp [5].
Remove the following:
– Bolts [1]
– Clamp [2]
– Sensor bolt [3]
– Rear wheel speed sensor [4]
Installation is in the reverse order of removal.
• Clean the sensor tip and sensor installation area
(caliper bracket) thoroughly, and be sure that no
foreign materials are allowed.
• Always replace the rear wheel speed sensor
mounting bolt with new a one.
• The clearance gap cannot be adjusted.
If it is not within specification, check related part for
deformation, looseness, or damage.
After installation, check the air gap (page 19-23).
ANTI-LOCK BRAKE SYSTEM (ABS)
[3]
[5]
[1]
[4]
[3]
[4]
[2]
[2]
[1]
19-25