Honda CBR650RA Shop Manual page 375

dummyhead dummyhead
Pour the specified amount of recommended fork fluid.
RECOMMENDED FORK FLUID:
Fork fluid (viscosity: 10W)
FORK FLUID CAPACITY:
465 ± 2.5 cm
Slowly push the outer tube [1] and pump the fork pipe
several times to remove the trapped air from the lower
portion of the fork pipe.
Leave it for 5 minutes to remove air bubbles from the
fluid.
Position the outer tube so that the distance between the
dust seal flat part [2] and the top of the axle holder [3] is
20 mm (0.8 in) as shown, and measure the oil level
from the top of the slide pipe.
FORK FLUID LEVEL: 90 mm (3.5 in)
Install the spring collar [1].
Install the fork spring [2] into the slide pipe assembly
with the tightly wound side facing down.
Apply fork fluid to the O-rings [1].
Install the fork rod assembly by pushing the rod guide
case [2] into the slide pipe assembly.
3 (15.7 ± 0.08 US oz, 16.3 ± 0.09 Imp oz)
FRONT WHEEL/SUSPENSION/STEERING
[1]
[2]
20 mm
[3]
(0.8 in)
[1]
[1]
90 mm
(3.5 in)
[2]
[2]
16-33