Honda CBR650RA Shop Manual page 390

dummyhead dummyhead
REAR WHEEL/SUSPENSION
REAR WHEEL
REMOVAL/INSTALLATION
Loosen the axle nut [1].
Support the motorcycle using a hoist or equivalent and
raise the rear wheel off the ground.
Loosen the lock nuts [2] and turn the adjusting bolts [3]
so the wheel can be moved forward all the way.
Remove the axle nut, washer [4] and right adjusting
Support the caliper
plate [5].
so it does not hang
from the brake
hose. Do not twist
the brake hose
Push the rear wheel forward.
Remove the axle [1] and left adjusting plate [2].
Derail the drive chain [3] from the driven sprocket and
remove the rear wheel.
• Do not operate the brake pedal after removing the
wheel.
Remove the following:
– Left side collar (flange) [1]
– Right side collar [2]
Installation is in the reverse order of removal.
• When installing the wheel, take care not to let the
caliper bracket [1] come off the swingarm boss [2]
and not to damage the brake pads.
• The axle is installed from the left side.
Adjust the drive chain slack (page 3-15).
TORQUE:
Rear axle nut: 98 N·m (10.0 kgf·m, 72 lbf·ft)
17-4
[4]
[5] [1]
[1]
Left side: [1] Right side:
[2]
[1]
[2]
[3]
[3]
[2]
[2]