Honda CBR650RA Shop Manual page 353

dummyhead dummyhead
INSTALLATION (CB650RA)
Apply grease to the cable groove and roll-up area of the
throttle grip [1].
Install the throttle grip/housing assembly onto the
handlebar [2].
Install the handlebar [1] and upper holder [2]. Tighten
Align the punch
the front socket bolts [3] first, then tighten the rear
mark with the edge
socket bolts [4] to the specified torque.
of the top bridge.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Install the rear throttle housing [1] by aligning the
locating pin with the hole in the handlebar.
Tighten the upper screw [2] first, then tighten the lower
screw [3] securely.
Install the front right handlebar switch housing [1] by
aligning the locating pin with the hole in the handlebar.
Install the rear right handlebar switch housing [2].
Tighten the upper screw [3] first, then tighten the lower
screw [4] to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
FRONT WHEEL/SUSPENSION/STEERING
[2]
[2]
[1]
[4]
Align
[1]
Align
[1]
[1]
[3]
Align
[2]
[3]
[3]
[2]
[4]
16-11