Honda CBR650RA Shop Manual page 416

dummyhead dummyhead
HYDRAULIC BRAKE
INSPECTION
Check the following parts for scoring, scratches, deterioration or damage.
– Caliper cylinder
– Caliper piston
Measure the parts according to HYDRAULIC BRAKE SPECIFICATIONS (page 1-10) and replace if necessary.
BRAKE PEDAL
REMOVAL/INSTALLATION
Support the right rider footpeg bracket [1] securely and
remove the bracket socket bolts [2].
Remove the following:
– Switch spring [1]
– Return spring [2]
– Cotter pin [3]
– Joint pin [4]
– Snap ring [5]
– Washer [6]
– Brake pedal [7]
Installation is in the reverse order of removal.
• Apply grease to the pedal pivot sliding area.
• Install the snap ring with the chamfered edge facing
the thrust load side and be certain it is firmly seated
in the groove. Do not reuse worm snap ring which
could easily spin in the groove.
• Replace the cotter pin with a new one.
• Install each spring in the direction as shown.
TORQUE:
Rider footpeg bracket socket bolt:
27 N·m (2.8 kgf·m, 20 lbf·ft)
18-16
[1]
[7]
[2] [1]
[2]
[5]
[6]
[4]
[3]