dummyhead
dummyhead
LIGHTS/METERS/SWITCHES
SERVICE INFORMATION
LIGHTS/METERS/SWITCHES
GENERAL
• Check the battery condition before performing any inspection that requires proper battery voltage.
• A continuity test can be made with the switches installed on the motorcycle.
• Use an electric heating element to heat the coolant for the ECT sensor inspection. Keep flammable materials away from the
electric heating element. Wear protective clothing, insulated gloves and eye protection.
• ED, IIED, IIIED, IVED, FO, IIFO, KO, IIKO models: If the ECM is replaced, perform the following procedure.
– Key Registration Procedures (page 22-4)
– Crank pulse initialize learning procedure (page 4-84)
• MA, IIMA, IN, TH, IITH, U, IIU, BR, IIBR models: If the ECM is replaced, perform the Key Registration Procedures (page 22-7).
• The following color codes are used throughout this section.
Bl = Black
G = Green
Br = Brown
Gr = Gray
Bu = Blue
Lb = Light Blue
SYSTEM LOCATION
IGNITION SWITCH
COMBINATION METER
CLUTCH SWITCH
ECT
SENSOR
HORN
21-2
Lg = Light Green
O = Orange
P = Pink
FRONT BRAKE LIGHT SWITCH
EOP SWITCH
SIDESTAND SWITCH
R = Red
W = White
Y = Yellow
FUEL PUMP UNIT
(FUEL LEVEL SENSOR)
TURN SIGNAL
RELAY
CONTROL RELAY:
– MAIN RELAY
– FUEL PUMP RELAY
– FAN CONTROL RELAY
REAR BRAKE LIGHT SWITCH
USB CHARGER UNIT
(Except KO, IIKO, U, IIU,
BR, IIBR models)