dummyhead
dummyhead
Loosen the six screws [1] fully and remove the intake
ducts [2].
Remove the air cleaner housing [3].
Remove the O-rings [1] from the air cleaner housing.
Installation is in the reverse order of removal.
• Replace the O-rings with new ones.
THROTTLE BODY
REMOVAL/INSTALLATION
• Always clean around the fuel system parts with
compressed air before removing to prevent dirt and
debris from entering the air passages in the throttle
body.
Remove the air cleaner housing (page 7-12).
Loosen the throttle cable A adjuster lock nut [1] and the
throttle cable B lock nut [2].
Disconnect the following:
– Fuel injector sub harness 6P (Black) connector [1]
– IACV 4P (Black) connector [2]
– TP sensor 3P (Blue) connector [3]
[2]
[1]
[1]
[1]
[2]
[3]
[1]
FUEL SYSTEM
[3]
[2]
7-13