dummyhead
dummyhead
BATTERY
REMOVAL/INSTALLATION
Remove the main seat (page 2-11).
Turn the ignition switch OFF.
Disconnect the negative (–) cable [1] first and then
disconnect the positive (+) cable [2] by removing the
terminal bolts.
Remove the rubber strap [3] and the battery [4].
Installation is in the reverse order of removal.
• Connect the positive (+) cable first, then connect the
negative (–) cable.
• For digital clock setting procedure (page 21-10).
VOLTAGE INSPECTION
Remove the main seat (page 2-11).
Measure the battery voltage using a digital multimeter.
VOLTAGE (20°C/68°F):
Fully charged:
Needs charging: Below 12.3 V
• When measuring the battery voltage after charging,
leave it for least 30 minutes, or the accurate results
cannot be obtained because the battery voltage
fluctuates just after charging.
12.8 V minimum
BATTERY/CHARGING SYSTEM
[3]
[4]
[1]
(–)
(+)
[2]
20-5