dummyhead
dummyhead
Place a new bearing [1] with the marked side facing
down. Install the driven flange collar [2] into the bearing
until it is fully seated.
TOOLS:
[3] Driver
[4] Attachment, 28 x 30 mm
[5] Pilot, 20 mm
Drive in the driven flange bearing/collar squarely with
the collar side facing down until it is fully seated.
TOOLS:
Driver
[6] Attachment, 52 x 55 mm
[7] Pilot, 20 mm
DRIVEN FLANGE STUD BOLT REPLACEMENT
Check that the length from the bolt head to the driven
flange surface is within specifications.
STANDARD:19.5 – 21.0 mm (0.77 – 0.83 in)
When removing the driven flange stud bolts, install and
tighten new stud bolts into the driven flange so that the
length from the bolt head to the driven flange surface is
within specifications.
• When installing the driven flange stud bolt, Apply
locking agent to the stud bolt as shown.
07749-0010000
07946-1870100
07746-0040500
[2]
07749-0010000
07746-0010400
[1]
07746-0040500
REAR WHEEL/SUSPENSION
[3]
[4]
[5]
[7]
19.5 - 21.0 mm
(0.77 – 0.83 in)
[3]
[6]
17-7