Honda CBR650RA Shop Manual page 465

dummyhead dummyhead
REMOVAL/INSTALLATION
Remove the tank cover (page 2-7).
Remove the two clips [1] and ignition switch cover [2].
Disconnect
connector [1].
Remove the dust cover [2] and disconnect the ignition
switch 2P (Brown) connector [3].
Remove the wire clip [4]
Remove the following:
– Two socket bolts [1]
– Immobilizer receiver mount stay [2]
– Ignition switch [3]
– Ignition switch mount stay [4]
– Two screws [5]
– Immobilizer receiver [6]
– Two washers [7]
– Two collars [8]
– Two grommets [9]
Install the removed parts in the reverse order of
Route the wires
removal.
properly (page 1-
22)
TORQUE:
Ignition switch mounting bolt:
27 N·m (2.8 kgf·m, 20 lbf·ft)
• Replace the switch mounting socket bolts with new
ones.
• If the ignition switch is replaced, perform the key
registration procedures (page 22-7).
the immobilizer receiver
LIGHTS/METERS/SWITCHES
[1]
4P (Black)
[1]
[7]
[9]
[2]
[3]
[4]
[2]
[2]
[4]
[1]
21-15
[3]
[6]
[8]
[5]