dummyhead
dummyhead
CLUTCH/GEARSHIFT LINKAGE/STARTER CLUTCH
Apply engine oil to the starter clutch outer mounting bolt
[1] threads and seating surface.
Install the washer [2] and starter clutch mounting bolt.
Temporarily install the following:
– Oil pump drive sprocket guide
– Oil pump drive sprocket
– Clutch outer guide
– Clutch outer [1]
– Clutch outer needle bearing
Attach the special tool between the primary drive gear
Be careful not to
and driven gear.
drop the gear holder
into the crankcase.
TOOL:
[2] Gear holder, M2.5
Tighten the starter clutch outer mounting bolt [3] to the
specified torque.
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Remove the temporarily installed parts.
Apply molybdenum oil solution to the starter reduction
gear [1] sliding surface.
Install the starter reduction gear into the crankcase.
Install the clutch (page 11-10).
11-18
MA, IIMA, IN, TH, IITH, U, IIU, BR, IIBR models shown:
MA, IIMA, IN, TH, IITH, U, IIU, BR, IIBR models shown:
07724-0010100
[1]
[1]
[3]
[2]
[1]
[2]