Honda CBR650RA Shop Manual page 398

dummyhead dummyhead
REAR WHEEL/SUSPENSION
SWINGARM PIVOT BEARING
REPLACEMENT
RIGHT SIDE
Remove the snap ring [1].
Press the ball bearing [1] and needle bearing [2] out of
the right pivot using the special tools.
TOOLS:
[3] Driver, 15 x 280L
[4] Attachment, 24 x 26 mm
[5] Pilot 20 mm
Apply molybdenum disulfide grease to the rotating area
of a new ball bearing.
Install the ball bearing [1] into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot 20 mm
Apply molybdenum disulfide grease to a new needle
bearing rotating area.
Install the needle bearing [1] into the right pivot with the
marked side facing out until it is fully seated using a
hydraulic press and special tools as shown.
TOOLS:
[2] Driver
[3] Attachment, 37 mm
[4] Pilot 30 mm
17-12
07949-3710001
07746-0010700
07746-0040500
07749-0010000
07ZMD-MBW0200
07746-0040500
07749-0010000
07ZMD-MBW0200
07746-0040700
[1]
[3]
[4]/[5]
[1]
[2]
[2]
[3]/[4]
[1]
[2]
[3]/[4]
[1]