Honda CBR650RA Shop Manual page 303

dummyhead dummyhead
LEFT CRANKCASE COVER
REMOVAL/INSTALLATION
Support the motorcycle in an upright position on a level
surface.
Remove the following:
– Left middle cowl (page 2-7) (CBR650RA)
– Under cowl (page 2-11) (CBR650RA)
Lift the fuel tank and support it (page 3-4).
Disconnect the alternator 3P (Gray) connector [1].
Disconnect the ECM 33P connectors (page 4-76).
Release the alternator wire clip [1].
Remove the alternator wire [2] out of the frame.
• Place a clean oil pan under the engine because
engine oil will flow out when removing the left
crankcase cover. Add the recommended engine oil
to the specified level after installation (page 3-10).
Remove the following:
– Left crankcase cover bolts [1]
– Under cowl stay (CBR650RA only) [2]
– Left crankcase cover [3]
• The left crankcase cover (stator) is magnetically
attracted to the flywheel, be careful during removal
and installation.
Remove the dowel pins [1].
Clean any sealant off from the alternator cover mating
Be careful not to
surfaces.
damage the mating
surfaces.
[1]
[2]
[2] (CBR650RA only)
[1]
ED, IIED, IIIED, IVED, FO, IIFO, KO, IIKO models
shown:
ALTERNATOR
[1]
[3]
[1]
12-3