Honda CBR650RA Shop Manual page 440

dummyhead dummyhead
ANTI-LOCK BRAKE SYSTEM (ABS)
Remove the bolt [1] and front wheel speed sensor wire
guide [2].
Release the front wheel speed sensor wire [3] from the
clamp [4].
Remove the wire clip [5].
Remove the front wheel speed sensor guard bolts [1].
Remove the bolt [2] and front wheel speed sensor [3]
from wheel speed sensor guard [4].
Installation is in the reverse order of removal.
• Clean around the sensor tip and sensor installation
area (front wheel speed sensor guard) thoroughly,
and be sure that no foreign material is allowed to
enter the mounting hole.
• Always replace the front wheel speed sensor
mounting bolt and front wheel speed sensor guard
mounting bolts with new ones.
• The clearance gap cannot be adjusted.
If it is not within specification, check related part for
deformation, looseness, or damage.
After installation, check the air gap (page 19-23).
REAR WHEEL SPEED SENSOR
Remove the drive chain cover/mud guard (page 2-16).
Lift the fuel tank and support it (page 3-4).
Disconnect the rear wheel speed sensor 2P (Black)
connector [1].
Remove the wire clip [1].
Release the rear wheel speed sensor wire [2] from the
clamp [3].
19-24
ED model shown:
[1]
[3]
[5]
[1]
[3]
[1]
[2]
[4]
[4]
[2]
[1]
[2]
[3]