Adding An Ipv6 Address; Deleting An Ipv6 Address; Managing Mpls - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
!
If no addresses have been configured, add addresses as needed. For more information, refer to
"Adding an IPv6 Address".
Section 5.40.6.2

Adding an IPv6 Address

To add an IPv6 address to a routable interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the address by typing:
ip interface ipv6 address address
Where:
• interface is the name of the interface
• address is the IPv6 address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.40.6.3

Deleting an IPv6 Address

To delete an IPv6 address for a routable interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no ip interface ipv6 address address
Where:
• interface is the name of the interface
• address is the IPv6 address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.41

Managing MPLS

MPLS (Multi-Protocol Label Switching) operates between layer 2 and layer 3 of the OSI (Open Systems
Interconnection) model and provides a mechanism to carry traffic for any network layer protocol. MPLS makes
forwarding decisions based on labels where the labels are mapped to destination IP networks. MPLS traffic flows
are connection-oriented, as it operates on a pre-configured LSPs (Label Switch Paths) that are built based on the
dynamic Label Distribution Protocol (LDP), or through static label bindings.
The following sections describe how to configure and manage MPLS:
• Section 5.41.1, "Viewing the Status of IP Binding"
• Section 5.41.2, "Viewing the Status of the Forwarding Table"
598
RUGGEDCOM ROX II
CLI User Guide
Section 5.40.6.2,
Adding an IPv6 Address