Viewing A List Of Vlans For T1/E1 Lines; Adding A Vlan To A Routable Ethernet Port - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.37.8.2

Viewing a List of VLANs for T1/E1 Lines

To view a list of VLANs configured for either a T1 or E1 line, type:
show running-config interface wan slot port protocol channel number connection hdlc-eth vlan
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• protocol is either T1 or E1
• number is the channel number
If VLANs have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface wan lm4 1 t1 channel 1 connection hdlc-eth vlan
interface
wan lm4 1
t1 channel 1
connection hdlc-eth vlan 4024
!
!
!
!
If no VLANs have been configured, add VLANs as needed. For more information about configuring VLANs for
either a T1 or E1 line, refer to
Section 5.37.8.3

Adding a VLAN to a Routable Ethernet Port

To add a VLAN to a routable Ethernet port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new VLAN by typing:
interface eth interface-name vlan id
Where:
• interface-name is the name of the interface
• id is the ID of the VLAN
3. Configure the following parameter(s) as required:
Parameter
ip-address-src { ip-address-src }
on-demand
558
Section 5.37.8.4, "Adding a VLAN to a T1/E1 Line".
Description
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP. The DYNAMIC option is a common case of a
dynamically assigned IP address. It switches between BOOTP
and DHCP until it gets the response from the relevant server. It
must be static for non-management interfaces.
Synopsis: typeless
This interface is up or down on the demand of the link failover.
Viewing a List of VLANs for T1/E1 Lines
RUGGEDCOM ROX II
CLI User Guide