Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Section 3.20.8.2
Adding a Device Address Table
To add a Device Address table for a serial port using the DNP protocol, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
interface serial slot port protocols dnp setdnp device-table address
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• address is the local or remote DNP device address. The address may be that of a DNP device connected
to a local serial port or one available via the serial port of a remote IP host.
3.
Configure the following parameter(s) as required:
Parameter
remote-ip { remote-ip }
remote-device
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.20.8.3
Deleting a Device Address Table
To delete a Device Address table, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the Device Address Table by typing:
no interface serial slot port protocols dnp setdnp device-table address
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• address is the local or remote DNP device address. The address may be that of a DNP device connected
to a local serial port or one available via the serial port of a remote IP host.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Adding a Device Address Table
Description
Synopsis: A string 7 to 15 characters long or a string 6 to 40
characters long
The IP address of the remote host that provides a connection
to the DNP device with the configured address. Leave this field
empty to forward DNP messages that match the configured
address to the local serial port.
Synopsis: typeless
Enables forwarding of DNP messages that match the device
address to the remote IP.
Chapter 3
Device Management
119
Advertisement
Table of Contents
Troubleshooting
