Chapter 3
Device Management
admin logging server address
Where:
• address is the IP address of the remote server
3.
Configure the following parameter(s) as required:
Parameter
enabled
transport { transport }
monitor-interface { monitor-interface }
port { port }
4.
Configure one or more selectors for the server. For more information, refer to
Remote Server
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 3.9.6.3
Deleting a Remote Server
To delete a remote server, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the remote server by typing:
no admin logging server address
Where:
• address is the IP address of the remote server.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.9.7
Managing Remote Server Selectors
Remote server selectors filter the information sent to specific servers.
The following sections describe how to configure and manage remote server selectors:
•
Section 3.9.7.1, "Viewing a List of Remote Server Selectors"
•
Section 3.9.7.2, "Adding a Remote Server Selector"
•
Section 3.9.7.3, "Deleting a Remote Server Selector"
68
Selector".
Description
Synopsis: typeless
Enables/disables the feed to the remote logging server.
Synopsis: { udp, tcp }
Default: udp
TCP or UDP.
The interface to monitor. If the IP address is changed on the
interface, the logging daemon will restart.
Synopsis: An integer between 1 and 65535
Default: 514
Port number.
Section 3.9.7.2, "Adding a
RUGGEDCOM ROX II
CLI User Guide
Deleting a Remote Server