Viewing A List Of Vrf Definitions; Adding A Vrf Definition - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
address of the associated interface, it uniquely identifies each IP packet, allowing the Provider Edge (PE) to
determine which VPN tunnel the packet belongs to.
Each VRF definition can also be associated with one or more route targets.
The following sections describe further how to define and manage VRF definitions:
• Section 5.22.5.1, "Viewing a List of VRF Definitions"
• Section 5.22.5.2, "Adding a VRF Definition"
• Section 5.22.5.3, "Deleting a VRF Definition"
Section 5.22.5.1

Viewing a List of VRF Definitions

To view a list of VRF definitions, type:
show running-config global vrf
If definitions have been configured, a table or list similar to the following example appears:
show running-config global vrf | tab
global
vrf
definition
VRF VRF
NAME DESCRIPTION
-----------------------------------------------------------
vrf1 Site A
vrf2 Site B
!
!
If no VRF definitions have been configured, add definitions as needed. For more information, refer to
Section 5.22.5.2, "Adding a VRF
Section 5.22.5.2

Adding a VRF Definition

To add a VRF definition, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the definition by typing:
global vrf definition name
Where:
• name is the name for definition. The name must be unique and not exceed 32 characters or contain
spaces. The first character must also not be a special character. Only the following special characters are
permitted in the remainder of the name: hyphen (-), underscore (_), colon (:), and period (.).
3. Configure the following parameter(s) as required:
384
EXPORT IMPORT
RD COMMUNITY COMMUNITY
100:1
100:2
Definition".
BOTH
COMMUNITY
100:2
100:1
RUGGEDCOM ROX II
CLI User Guide
Viewing a List of VRF Definitions