RUGGEDCOM ROX II
CLI User Guide
Parameter
dstmac { dstmac }
proto { proto }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
6.
Add the rule to a virtual switch filter. For more information, refer to
Virtual Switch
Filter".
Section 3.24.6.4
Adding a Rule to a Virtual Switch Filter
To add a rule to a virtual switch filter, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the rule by typing:
security virtualswitch-filter virtualswitch name rule rule enable
Where:
• name is the name of the virtual switch filter
• rule is the name of the rule
3.
Configure the in/out interfaces for the rule. For more information, refer to
Interfaces".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.24.6.5
Deleting a Rule
To delete a rule used to filter virtual switch traffic, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the rule by typing:
no security virtualswitch-filter rules rule
Where:
• rule is the name of the rule
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Adding a Rule to a Virtual Switch Filter
Description
The required source MAC address for incoming frames.
Synopsis: A string
The required destination MAC address for incoming frames.
Synopsis: { iso, arp, ipv4, ipv6 } or a string
The pre-defined protocol or hex-string (i.e. 0x88A2) used to
create the frames.
Section 3.24.6.4, "Adding a Rule to a
Section 3.24.7.2, "Adding In/Out
Chapter 3
Device Management
153