Configuring The Source Zone; Configuring The Destination Zone; Deleting A Policy - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.17.11.3

Configuring the Source Zone

To configure the source zone for a firewall policy, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to security » firewall » fwconfig » {firewall} » fwpolicy » {policy} » source-zone, where
2.
{firewall} is the name of the firewall and {policy} is the name of the policy.
3. Configure the following parameter(s) as required:
Default: all
Parameter
predefined-zone { predefined-zone }
all
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.17.11.4

Configuring the Destination Zone

To configure the destination zone for a firewall policy, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter
predefined-zone { predefined-zone }
all
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.17.11.5

Deleting a Policy

To delete a policy, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the policy by typing:
no security firewall fwconfig firewall fwpolicy policy
Where:
• firewall is the name of the firewall
• policy is the name of the policy
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Configuring the Source Zone
Description
Description
Chapter 5
Setup and Configuration
285