Chapter 5
Setup and Configuration
NOTE
For more information about route map filters, refer to
The following sections describe how to configure and manage incoming route filters:
•
Section 5.21.7.1, "Viewing List of Incoming Route Filters"
•
Section 5.21.7.2, "Adding an Incoming Route Filter"
•
Section 5.21.7.3, "Deleting an Incoming Route Filter"
Section 5.21.7.1
Viewing List of Incoming Route Filters
To view a list of route filters configured for incoming advertised routes, type:
• For Standard OSPF Routes
show running-config routing ospf incoming-route-filter
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf incoming-route-filter
Where:
• vrf is the name of the chosen VRF
If route filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf incoming-route-filter
routing ospf
incoming-route-filter ospf_route_1
!
!
If no route filters have been configured, add filters as needed. For more information, refer to
"Adding an Incoming Route
Section 5.21.7.2
Adding an Incoming Route Filter
To add a route filter for incoming advertised routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Make sure a route map has been configured. For more information, refer to
Maps"
3.
Create the new incoming route filter by typing:
• For Standard OSPF Routes
routing ospf incoming-route-filter route-map
• For VRF Routes via OSPF
routing ospf vrf vrf incoming-route-filter route-map
Where:
372
Filter".
Section 5.21.6, "Managing Route
Section 5.21.6, "Managing Route
Viewing List of Incoming Route Filters
RUGGEDCOM ROX II
CLI User Guide
Maps".
Section 5.21.7.2,