RUGGEDCOM ROX II
CLI User Guide
Parameter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.4
Enabling and Configuring SFTP Sessions
To enable and configure SFTP sessions, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Configure the following parameter(s) as required:
Parameter
enabled
listen-ip { listen-ip }
port { port }
extra-ip-ports { extra-ip-ports }
max-sessions { max-sessions }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.5
Enabling and Configuring WWW Interface
Sessions
To enable and configure WWW interface sessions, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to admin » webui and configure the following parameter(s) as required:
Enabling and Configuring SFTP Sessions
Description
Sets the greeting presented when the user logs in to the CLI.
Description
Synopsis: true or false
Default: false
Enables/Disables the SFTP user interface.
Synopsis: A string
Default: 0.0.0.0
The IP Address the SFTP will listen on for SFTP requests.
Synopsis: An integer between 0 and 65535
Default: 2222
The port the SFTP will listen on for SFTP requests.
Synopsis: A string
The SFTP will also listen on these IP Addresses. For port values,
add ':#' to set non-default port value. (ie. xxx.xxx.xxx.xxx:19343
[::] [::]:16000). If using the default address, do not specify another
listen address with the same port.
Synopsis: { unbounded }
Default: 10
This parameter is not supported and any value is ignored by the
system.
Chapter 5
Setup and Configuration
195