Chapter 5
Setup and Configuration
•
Section 5.21.6.3, "Adding a Route Map Filter"
•
Section 5.21.6.4, "Adding a Route Map Filter Entry"
•
Section 5.21.6.5, "Deleting a Route Map Filter"
•
Section 5.21.6.6, "Deleting a Route Map Filter Entry"
•
Section 5.21.6.7, "Configuring Match Rules"
Section 5.21.6.1
Viewing a List of Route Map Filters
To view a list of route map filters for either dynamic OSPF routes, type:
• For Standard OSPF Routes
show running-config routing ospf filter route-map
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf filter route-map
Where:
• vrf is the name of the chosen VRF
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf filter route-map | tab
TAG
SEQ
ACTION
OPERATION
VALUE
---------------------------------------------------------------------------------------------
map
10
permit
-
-
!
If no filters have been configured, add filters as needed. For more information, refer to
a Route Map
Filter".
Section 5.21.6.2
Viewing a List of Route Map Filter Entries
To view a list of entries for a route map filter for either OSPF, type:
• For Standard OSPF Routes
show running-config routing ospf filter route-map tag entry
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf filter route-map tag entry
Where:
• vrf is the name of the chosen VRF
• tag is the tag for the route map filter
368
ON
MATCH
AS
PREFIX
NEXT
ORIGINATOR
CALL
GOTO
PATH
LIST
HOP
ORIGIN
ID
-
-
-
-
-
-
-
PREFIX
PREFIX
LIST
LIST
METRIC
WEIGHT
-
-
-
-
PEER
ORIGIN
AS
IP
-
-
-
-
Section 5.21.6.3, "Adding
Viewing a List of Route Map Filters
RUGGEDCOM ROX II
CLI User Guide
LOCAL
PREFERENCE
-