Deleting A Host - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
1. Make sure the CLI is in Configuration mode.
2. Add the host by typing:
security firewall fwconfig firewall fwhost name
Where:
• firewall is the name of the firewall
• name is the name of the host
3. Configure the host options by typing the following commands:
Parameter
ipsec
4. Configure the main host by typing the following commands:
Parameter
iptype { iptype }
zone { zone }
interface { interface }
ipaddress { ipaddress }
description { description }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.17.10.3

Deleting a Host

To delete a host, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the host by typing:
no security firewall fwconfig firewall fwhost name
Where:
• firewall is the name of the firewall
• name is the name of the host
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
282
Description
Synopsis: true or false
Default: false
Description
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used,
otherwise define IPv4 and IPv6 rules for each type of addresses
used.
A pre-defined zone
A pre-defined interface to which optional IPs and/or networks can
be added.
Synopsis: A string
Additional IP addresses or networks - comma separated, or a
range in the form of low.address-high.address
Synopsis: A string
(Optional) The description string for this host.
RUGGEDCOM ROX II
CLI User Guide
Deleting a Host