RUGGEDCOM ROX II
CLI User Guide
R3 18.18.18.18
.2
1.9.5.0/32
.2
R4 16.16.16.16
Figure 4: Multi-Level IS-IS Configuration
Section 5.18.3
Viewing the Status of Neighbors
To view the status of neighboring devices on an IS-IS network, do the following:
1.
Make sure IS-IS is configured. For more information, refer to
2.
View the status by typing:
routing status isis isis-neighbors-status
If IS-IS routes have been configured, a table similar to the following example appears:
ruggedcom# routing status isis isis-neighbors-status
isis-neighbors-status
Area area1:
System Id
Spirent-
This table displays the following information:
Parameter
System ID
Interface
L
State
Holdtime
Viewing the Status of Neighbors
3
1.3.5.0/32
.3
eth1
R1 78.78.78.78
.3
1.4.5.0/32
.2
R5 15.15.15.15
Interface
L
State
switch.0012 3
Up
192.168.12.0/24
.1 eth2
2
1.2.6.0/32
eth1
Section 5.18.2, "Configuring
Holdtime SNPA
24
2020.2020.2020
Description
The system ID.
The name of the interface.
The level.
Adjacency state.
The remaining hold time in seconds.
Setup and Configuration
192.168.11.0/24
.1 eth2
.2
eth1
R2 72.72.72.72
IS-IS".
Chapter 5
297