Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
admin connected from 127.0.0.1 using console on ruggedcom
ruggedcom#
Section 2.4
Logging Out
To log out of the device, type exit at the root level.
ruggedcom#
exit
Section 2.5
Using Network Utilities
The following sections describe how to use the built-in RUGGEDCOM ROX II network utilities:
•
Section 2.5.1, "Pinging a Host"
•
Section 2.5.2, "Dumping Raw Data to a Terminal or File"
•
Section 2.5.3, "Tracing the Route to a Remote Host"
•
Section 2.5.4, "Pinging an IPv4 Address Using MPLS Protocols"
•
Section 2.5.5, "Tracing the Route of an IPv4 Address Using MPLS Protocols"
•
Section 2.5.6, "Tracing Activities on a Serial Port"
Section 2.5.1
Pinging a Host
To ping a host, type:
• For Hosts with IPv4 Addresses
ping address iface interface count attempts wait seconds
• For Hosts with IPv6 Addresses
ping6 address iface interface count attempts wait seconds
Where:
• address is the IP address of the host
• attempts is the number of ping attempts
• interface is the interface to use
• seconds is the maximum number of seconds to for a response from the host
Logging Out
Chapter 2
Using RUGGEDCOM ROX II
19
Advertisement
Table of Contents
Troubleshooting
