RUGGEDCOM ROX II
CLI User Guide
• For VRF Routes via OSPF
routing ospf vrf vrf filter prefix-list name entry
Where:
• vrf is the name of the chosen VRF
• name is the name of the prefix list
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf filter prefix-list test entry | tab
SEQ
ACTION
SUBNET
---------------------------------------------
5
permit
192.168.40.0/24
6
deny
192.168.5.21/32
!
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a Prefix
Entry".
Section 5.21.4.3
Adding a Prefix List
To add a prefix list for dynamic OSPF routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the list by typing:
• For Standard OSPF Routes
routing ospf filter prefix-list name
• For VRF Routes via OSPF
routing ospf vrf vrf filter prefix-list name
Where:
• vrf is the name of the chosen VRF
• name is the name of the prefix list
3.
Configure the following parameter(s) as required:
Parameter
description { description }
4.
Add prefix entries as needed. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Adding a Prefix List
LE
GE
32
-
-
-
Description
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Section 5.21.4.4, "Adding a Prefix
Chapter 5
Setup and Configuration
Section 5.21.4.4,
Entry".
363