Viewing A List Of Dscp-To-Cos Mapping Entries; Adding A Dscp-To-Cos Mapping Entry; Deleting A Dscp-To-Cos Mapping Entry - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.34.3.1

Viewing a List of DSCP-to-CoS Mapping Entries

To view a list of priorites, type:
show running-config switch class-of-service dscp-to-cos
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config switch class-of-service dscp-to-cos | tab
DSCP COS
--------------
1 normal
3 high
4 medium
6 normal
7 normal
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a DSCP-to-CoS Mapping
Section 5.34.3.2

Adding a DSCP-to-CoS Mapping Entry

To add a DSCP-to-CoS mapping entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the entry by typing:
switch class-of-service dscp-to-cos dscp
Where:
• dscp is the value of the 6 bit DiffServ field in the Type-Of-Service (TOS) field of the IP header
3. Configure the following parameter(s) as required:
Parameter
cos { cos }
4. Configure the CoS parameters on select switched Ethernet ports and/or trunk interfaces as needed. For
more information, refer to
"Adding an Ethernet Trunk
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.34.3.3

Deleting a DSCP-to-CoS Mapping Entry

To delete a DSCP-to-CoS mapping entry, do the following:
508
Entry".
Section 3.17.2, "Configuring a Switched Ethernet Port"
Interface".
Description
Synopsis: { normal, medium, high, crit }
Default: normal
The Class of Service (CoS) assigned to the received frames with
the specified DSCP.
Viewing a List of DSCP-to-CoS Mapping Entries
RUGGEDCOM ROX II
CLI User Guide
Section 5.34.3.2,
and/or Section 3.21.2,