Configuring A Set; Managing Prepended And Excluded Autonomous System Paths - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 5.19.3.8

Configuring a Set

To configure matched rules for a route map filter entry, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to routing » bgp » filter » route-map » {tag} » entry » {number} » set, where {tag} is the tag for
2.
the route map filter and {number} is the sequence number for the entry.
3. Configure the following parameters as required:
Parameter
local-preference { local-preference }
next-hop { next-hop }
origin { origin }
originator-id { originator-id }
weight { weight }
as { as }
ip { ip }
operation { operation }
value { value }
4. Add pre-pended and/or excluded autonomous system paths. For more information, refer to
"Adding a Prepended Autonomous System Path Filter"
Autonomous System Path
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.19.4
Managing Prepended and Excluded Autonomous System
Paths
The following sections describe how to configure and manage prepended and excluded autonomous system
paths:
• Section 5.19.4.1, "Viewing a List of Prepended Autonomous System Path Filters"
Configuring a Set
Description
Local preference.
Synopsis: { peer } or a string 7 to 15 characters long
The next hop address (xxx.xxx.xxx.xxx/xx or peer to use peer address).
Synopsis: { egp, igp, incomplete }
The origin code.
Synopsis: A string 7 to 15 characters long
This parameter is not supported and any value is ignored by the system.
Weight.
Synopsis: An integer between 1 and 4294967295
AS number.
Prerequisite: as must be empty when ip is not configured.
Synopsis: A string 7 to 15 characters long
IP address of aggregator.
Prerequisite: ip must be empty when as is not configured.
Synopsis: { set, add, sub }
Set , add or subtract the metric value.
Prerequisite: Operation must be empty when value is not configured.
Value.
Prerequisite: value must be empty when operation is not configured.
filter".
and/or Section 5.19.4.4, "Adding an Excluded
Chapter 5
Setup and Configuration
Section 5.19.4.3,
321