RUGGEDCOM ROX II
CLI User Guide
Section 5.12.13.2
Adding a Server Key
To add a server key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the key by typing:
services ntp key id
Where:
• id is the ID assigned to the key
3.
Configure the following parameter(s) as required:
Parameter
value { value }
trusted
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.12.13.3
Deleting a Server Key
To delete a server key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the chosen key by typing:
no services ntp key id
Where:
• id is the ID assigned to the key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.12.14
Managing Server Restrictions
Server restrictions control access to the NTP servers.
The following sections describe how to configure and manage NTP server restrictions:
•
Section 5.12.14.1, "Viewing a List of Server Restrictions"
•
Section 5.12.14.2, "Adding a Server Restriction"
•
Section 5.12.14.3, "Deleting a Server Restriction"
Adding a Server Key
Description
Synopsis: A string
The key.
Synopsis: typeless
Mark this key as trusted for the purposes of authenticating peers
with symmetric key cryptography. The authentication procedures
require that both the local and remote servers share the same
key and key identifier.
Chapter 5
Setup and Configuration
227