RUGGEDCOM ROX II
CLI User Guide
Section 5.19.10.3
Deleting an Aggregate Address Option
To delete an option for an aggregate address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the option by typing:
no routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.19.11
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes handled
by the kernel. Routes for subnets that are directly connected to the router, but not part of the BGP network, can
also be advertised.
The following sections describe how to configure and manage redistribution metrics for BGP:
•
Section 5.19.11.1, "Viewing a List of Redistribution Metrics"
•
Section 5.19.11.2, "Adding a Redistribution Metric"
•
Section 5.19.11.3, "Deleting a Redistribution Metric"
Section 5.19.11.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic BGP routes, type:
show running-config routing bgp redistribute
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp redistribute
routing bgp
redistribute rip
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.19.11.2, "Adding a Redistribution
Section 5.19.11.2
Adding a Redistribution Metric
To add a redistribution metric for dynamic BGP routes, do the following:
1.
Make sure the CLI is in Configuration mode.
Deleting an Aggregate Address Option
Metric".
Chapter 5
Setup and Configuration
337