Chapter 5
Setup and Configuration
Section 5.21.4.4
Adding a Prefix Entry
To add an entry for a dynamic OSPF prefix list, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the entry by typing:
• For Standard OSPF Routes
routing ospf filter prefix-list name entry number
• For VRF Routes via OSPF
routing ospf vrf vrf filter prefix-list name entry number
Where:
• vrf is the name of the chosen VRF
• name is the name of the prefix list
• number is the sequence number for the entry
3.
Configure the following parameter(s) as required:
Parameter
action { action }
subnet { subnet }
le { le }
ge { ge }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.21.4.5
Deleting a Prefix List
To delete a prefix list for dynamic OSPF routes, do the following:
1.
Make sure the CLI is in Configuration mode.
NOTE
Deleting a prefix list removes all associate prefix entries as well.
2.
Delete the list by typing:
• For Standard OSPF Routes
no routing ospf filter prefix-list name
364
Description
Synopsis: { deny, permit }
Default: permit
Action.
Synopsis: A string 9 to 18 characters long
Network (xxx.xxx.xxx.xxx/xx).
Synopsis: An integer between 1 and 32
The maximum prefix length to match ipaddress within subnet.
Synopsis: An integer between 1 and 32
The minimum prefix length to match ipaddress within subnet.
RUGGEDCOM ROX II
CLI User Guide
Adding a Prefix Entry